My Community

Hello,

I have been having problems running VASP version greater than 5.2.2. I compiled version 5.2.11 with PGI with the same makefile I use for the 5.2.2 version. It compiles fine but when I try to run gives a segmentation fault somewhere midway through the calculation (actually right after the first non-self-consistent steps)

[c2818:12643] *** Process received signal ***
[c2818:12644] *** Process received signal ***
[c2818:12644] Signal: Segmentation fault (11)
[c2818:12644] Signal code: Address not mapped (1)
[c2818:12644] Failing at address: 0x70
[c2818:12646] *** Process received signal ***
[c2818:12646] Signal: Segmentation fault (11)
[c2818:12646] Signal code: Address not mapped (1)
[c2818:12646] Failing at address: 0x70
[c2818:12643] Signal: Segmentation fault (11)
[c2818:12643] Signal code: Address not mapped (1)
[c2818:12643] Failing at address: 0x70
[c2818:12645] *** Process received signal ***
[c2818:12645] Signal: Segmentation fault (11)
[c2818:12645] Signal code: Address not mapped (1)
[c2818:12645] Failing at address: 0x70
[c2818:12646] *** End of error message ***
[c2818:12643] *** End of error message ***
[c2818:12644] *** End of error message ***
[c2818:12645] *** End of error message ***
----------------------------------------------------------------------mpirun noticed that process rank 3 with PID 12646 on node c2818.local exited on signal 11 (Segmentation fault).
----------------------------------------------------------------------

Anyone having a problem like that?
Also where can I get makefiles for Intel and GFortran for Linux? The ones distributed with the source are obsolete (and there isn't one for Gfortran).

1) please always use the makefiles which are delivered with the respective release of the code.
2) for the intel compiler please use the makefile.linux_ifc_P4 (please replace ifc by ifort)