Molecular Dynamics - Bug Report

Problems running VASP: crashes, internal errors, "wrong" results.


Moderators: Global Moderator, Moderator

Post Reply
Message
Author
marekmihalkovic
Newbie
Newbie
Posts: 1
Joined: Mon Nov 11, 2019 4:29 pm

Molecular Dynamics - Bug Report

#1 Post by marekmihalkovic » Wed May 20, 2020 11:37 am

REPORT Bug in VASP: vasp.5.3.3

Error description:

We would like to report an error discovered while attempting to run constant volume MD simulation on a supercell of face centered diamond-cubic Silicon lattice (Pearson symbol cF8). We enclose three setup folders packed into archive file data.tgz. Each setup folder contains files INCAR, POSCAR, POTCAR, KPOINTS, OUTCAR, job.out. The last file is the standard output.

1. The initial problem had occured before the first ionic step finished:

file setup1/job.out:

RSPHER: internal ERROR: 624 -43 576 -43

This behaviour was repreduced for several setups:

* Si, Ge: cF8, the same structure
* 2x2x2 (64 atoms) as well as 3x3x3 (216 atoms) supercell
* PBE and GGA PAW pseudopotential

2. Afterwards we set ISYM = 0 and after several ionic steps we obtained different error:

file setup2/job.out:

ERROR FEXCP: supplied Exchange-correletion table
is too small, maximal index : 11915

3. folder setup3: Finally, we have set ISYM to its default value and randomly displaced several atoms out of their symmetric positions and subsequently simulation ended without error.

We suspect that this erroneous behaviour is caused by implementation of symmetry constraints.
You do not have the required permissions to view the files attached to this post.

ferenc_karsai
Global Moderator
Global Moderator
Posts: 460
Joined: Mon Nov 04, 2019 12:44 pm

Re: Molecular Dynamics - Bug Report

#2 Post by ferenc_karsai » Tue May 26, 2020 6:19 am

This is a very old version of VASP, the problems are most likely resolved in the newest versions of VASP.
Also setup 1 is a bad setup, since running an MD with ISYM>0 is not good.

Post Reply