VASP interrupt when run MD simulation

[gniding]

Dear Everyone,

When I run the MD simulation using VASP, there always interrupts at hundred MD steps. You can see the error as follows:
-------------------------------------------------------
Primary job terminated normally, but 1 process returned
a non-zero exit code. Per user-direction, the job has been aborted.
-------------------------------------------------------
Could anybody know any possible reasons to induce this issue, such as the incorrect installation of vasp or some problems in the supercomputer?

Thanks ALL

[merzuk.kaltak]

Please upload a full error report and read the forum posting guide lines

[gniding]

Dear Sir,

Due to the OUTCAR file is too large, I deleted the middle part of the simulation. Please kindly find the error report files in attached.

Thanks so much for your help.

[henrique_miranda]

Hi, to reduce the size of your OUTCAR you can use the NWRITE variable:
wiki/index.php/NWRITE
For relatively long MD runs you might want to use NWRITE=0.

With the information you provide its hard to exactly pin-point where the issue might come from.
Here are a couple of hints:
1. the job might be killed by due to walltime limit. How long does the job run for?
2. the job is hitting some kind of memory limit.
Recently we've found a memory leak that occurs in MD runs when NWRITE>=1. This issue has been fixed in VASP6

Let me know if any of these points helps you.